Table of Contents
Advertisement
6.4 Connecting to an Ethernet LAN
The moisture.IQ Ethernet port supports the
modular connector is provided on the moisture.IQ rear panel for connection to the
WARNING! The Ethernet capability provided in the moisture.IQ is designed for use on a
limited-access Local Area Network (LAN) protected by a suitable firewall. It should not be operated if
exposed to the Internet or other unmanaged Wide Area Network (WAN). Check with your network
administrator to determine whether it is safe to connect the moisture.IQ to your network
infrastructure.
WARNING! As shipped from the factory, there are two accounts enabled, with default passwords
assigned. It is highly recommended that the default passwords be changed before placing the
moisture.IQ into service.
Note: This chapter assumes that you have read Chapters 1 and 2, and are familiar with the operation and installation
of the moisture.IQ electronics and user interface.
Note: Contact your network administrator to obtain the proper information to use in the following section.
6.4.1 Configuring the Ethernet TCP/IP Connection
The moisture.IQ can either be configured with a static Internet Protocol (
Configuration Protocol (
required. To configure the moisture.IQ
1. From the Configuration Menu screen (see Figure 52 on page 57), tap the
screen similar to Figure 69 below.
moisture.IQ User's Guide
10Base-T
DHCP
) to obtain an address from a
TCP/IP
connection, complete the following steps:
Figure 69: TCP/IP Setup Screen
100Base-TX
and
twisted-pair Ethernet standards. An
IP
) address or it can use the Dynamic Host
DHCP
server or router. No further address configuration is
Chapter 6. Setting Up Communications
LAN
.
TCP/IP
button to open a TCP/IP Setup
RJ-45
female
75
Advertisement
Table of Contents
