Table of Contents
Advertisement
Chapter 4
Configuring the Router
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
copy nvram:startup-config {ftp: | rcp: | tftp:}
Example:
Router# copy nvram:startup-config ftp:
Step 3
show {flash0 | flash1}:
Example:
Router# show {flash0|flash1}:
Step 4
copy {flash0 | flash1}: {ftp: | rcp: | tftp:}
Example:
Router# copy {flash0|flash1}: ftp:
Examples
Copying the Startup Configuration to a TFTP Server: Example
The following example shows the startup configuration being copied to a TFTP server:
Router# copy nvram:startup-config tftp:
Remote host[]? 172.16.101.101
Name of configuration file to write [rtr2-confg]? <cr>
Write file rtr2-confg on host 172.16.101.101?[confirm] <cr>
![OK]
Copying from Flash Memory to a TFTP Server: Example
The following example shows the use of the show {flash0 | flash1}: command in privileged EXEC mode
to determine the name of the system image file, and the use of the copy {flash0|flash1}: tftp: command
in privileged EXEC mode to copy the system image to a TFTP server. The router uses the default
username and password.
OL-21559-01
enable
copy nvram:startup-config {ftp: | rcp: | tftp:}
show {flash0 | flash1}:
copy {flash0 | flash1}: {ftp: | rcp: | tftp:}
Performing the Initial Configuration on the Router
Purpose
Enables privileged EXEC mode.
•
Enter your password if prompted.
Copies the startup configuration file to a server.
Configuration file copy can serve as a backup copy.
•
Enter the destination URL when prompted.
•
Displays the layout and contents of a flash memory file
system.
Learn the name of the system image file.
•
Copies a file from flash memory to a server.
Copy the system image file to a server to serve as a
•
backup copy.
Enter the filename and destination URL when
•
prompted.
Cisco Connected Grid Routers 2010 Hardware Installation Guide
4-23
Advertisement
Table of Contents
