Listening To The Dab+ (X-Smc02D Only); Tuning - Pioneer X-SMC02 Operating Instruction

Using the tuner
Listening to the DAB+ (X-SMC02D
only)

Tuning

1 Press the TUNER until "DAB" appears on
the display.
When turned on for the first time, the unit scans radio
stations automatically to create a station list.
The stations will be stored in alphanumeric order and the first
station on the list will be selected and you will hear it through
the speakers.
2 Press the TUNE +/– to select the desired
station.
3 Within 10 seconds, press the ENTER on
the remote control to tune into the desired
station.
• If no station is found, "NO SIG" appears.
• Up to 100 appears for total received stations.
Auto Scan
You can make the auto scan again when you move the unit
to other areas or add multiplex channels to the station list.
1 Press the TUNER until "DAB" appears on the display.
2 Press MENU and then press / until "DAB SCAN"
appears on the display.
3 Press ENTER and then press / until "AUTO"
appears on the display.
4 Press ENTER.
Auto Scan scanning begins.
After the scanning process is complete, the first station that
was detected is selected.
Manual tune
You can manually store stations which Auto Scan cannot
find. If reception is poor, you can adjust the sensitivity.
Manual tune is only available after Auto tune. Perform Auto
Scan first.
1 Press the TUNER until "DAB" appears on the display.
2 Press MENU and then press / until "DAB SCAN"
appears on the display.
Press ENTER and then press / until "MANUAL"
3
appears on the display.
4 Press ENTER.
5 Within 10 seconds, press the TUNE +/– to select the
DAB+ frequency.
6 Within 10 seconds, press the ENTER.
• If the level is too low, move the aerial or unit to improve
reception.
07
19
En