Voice Guide - Kenwood TK-7360 Instruction Manual

Auto Reply Message
You can set the transceiver to automatically respond to Individual Calls.
1 Press the key programmed as Auto Reply Message.
• "AUTO REPLY" momentarily appears on the display.
2 When you receive an Individual Call, Auto Reply will begin after waiting for
3 seconds, the transceiver will send an automatic response to the caller,
and "GREETING" appears on the display
• If you are available to receive the call, press any key to cancel the auto
response.
• If there is a channel available on your transceiver for recording, "I am not
available. Leave your Message." will be sent to the caller. The caller can then
leave a recorded message on your transceiver which you can later recall and
listen to. When a message is stored on your transceiver, "MSG RCVD" appears
on the display.
• If there is no channel available on your transceiver for recording, "I am not
available" will be sent to the caller and "MEM FULL" appears on the display.
Playback
You can play back a recorded conversation, memo, or message.
1 Press the key programmed as Playback.
• If the last action on your transceiver was to auto record your conversation,
"STORE" will appear on the display, otherwise a recording channel with the time
of the recording will appear.
2 Press /
• "AR" represents auto recordings.
• "VM" represents voice memos.
• "RM" represents reply messages.
3 The transceiver will announce the time and channel, then the recording will
play back.
• When the entire recording has been played, "END OF MSG" is displayed.
• Press A or # to delete the selected recording. Press and hold A or # to delete all
recorded data.
V G
OICE UIDE
If set up by your dealer, when changing the zone and/or channel/group ID,
an audio voice will announce the new zone and channel number/group ID.
Additionally, when changing a function setting, an audio voice will announce the
new setting. (Voice announcements vary by dealer setting.)
18
to select the channel you want to play back.