Advertisement
Quick Links
INSTALLATION
INSTRUCTIONS
PARTS LIST
Hood switch harness
Hood switch
Harness bracket
(Not used if equipped
with fog lights)
Cable clip
13 Wire ties
2 Wire ties with clips
TOOL AND SUPPLIES REQUIRED
#2 Phillips screwdriver
Small flat-tip screwdriver
Felt-tip pen
10 mm Combination wrench
10 mm Socket
Ratchet
Torx wrench
Isopropyl alcohol
Shop towel
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
Accessory
SECURITY SYSTEM
HOOD SWITCH
P/N 08E49-S9A-100
Illustration of the Hood Switch Installed on the
Vehicle
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by "do-it-yourselfers."
1.
2.
3.
AII 24665 (0210)
Application
2003 CR-V
HOOD SWITCH
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
Disconnect the negative cable from the battery.
Turn the knob clockwise, release the one
retaining tab, and remove the driver's dashboard
under cover.
DRIVER'S
DASHBOARD
UNDER
COVER
RETAINING
KNOB
TAB
Publications No.
AII 24665
Issue Date
OCT 2002
SECURITY UNIT
HOOD SWITCH
HARNESS
1 of 6
08E49-S9A-1000-91
Advertisement
Summary of Contents for Honda 08E49-S9A-100
- Page 1 Felt-tip pen 10 mm Combination wrench 10 mm Socket DRIVER’S Ratchet DASHBOARD Torx wrench UNDER COVER Isopropyl alcohol Shop towel RETAINING KNOB 1 of 6 08E49-S9A-1000-91 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24665 (0210)
- Page 2 CLIPS (8) SELF-TAPPING LEFT FRONT SCREW INNER FENDER Remove the kick panel (two clips and pull). CLIPS (2) CLIPS (3) TORX BOLT KICK PANEL 2 of 6 AII 24665 (0210) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
- Page 3 HOOD LOCK BRACKET 3 of 6 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24665 (0210)
- Page 4 WIRE TIE SWITCH FRONT HOOD SWITCH BOLT (reused) CLIP HOOD CENTER SWITCH SUPPORT HOOD OPENER 2-PIN HARNESS CABLE CONNECTOR CLIP NEW HOOD SWITCH 4 of 6 AII 24665 (0210) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
- Page 5 Using isopropyl alcohol on a shop towel, clean the inner fender. Remove the adhesive backing from the cable clip, and attach it to the left inner fender. 5 of 6 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24665 (0210)
- Page 6 NOTE: If the radiator fan comes on during this step, the time when it is operating must not be included in the 5 minutes. 6 of 6 AII 24665 (0210) © 2002 American Honda Motor Co., Inc - All Rights Reserved.