Using The Bno Usb Stick - Bosch BNO055 User Manual

3. Using the BNO USB stick

1. Make sure the switch at the end of the USB stick is in position H (see figure 1).
2. Plug USB stick into the USB port of your PC. The red LED on the stick should glow.
3. Start Development Desktop. You should see the main window:
4. On startup, the BNO055 is in CONFIG_MODE. Select an operation mode in the box
right to the Config Mode or simply disable CONFIG_MODE (see red indications on
image above).
5. Once CONFIG_MODE is disabled, you can start streaming:
6. Check the BNO055 data sheet and the Development Desktop documentation for more
options.
The help file outlining BNO use in Development Desktop environment is under :
Help->User Manuals->BNO055 User Manual
BST-BNO055-AN009-00 | Revision 1.0 | August 2014
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying and passing on to
third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
Note: Specifications within this document are subject to change without notice.
Application note
BNO055 – USB stick user guide
Page 4
Bosch Sensortec