Verify The Configuration - HP A7500 Series Configuration Manual

[SwitchB] ip route-static 10.1.1.0 255.255.255.0 tunnel 0

Verify the configuration

3.
# After the configuration, view the tunnel interface status on Switch A and Switch B respectively.
[SwitchA] display interface Tunnel 0
Tunnel0 current state: UP
Line protocol current state: UP
Description: Tunnel0 Interface
The Maximum Transmit Unit is 1456
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 2002::1:1, destination 2001::2:1
Tunnel protocol/transport GRE/IPv6
GRE key disabled
Checksumming of GRE packets disabled
Last clearing of counters:
Last 300 seconds input:
Last 300 seconds output:
10 packets input,
0 input error
10 packets output,
0 output error
[SwitchB] display interface Tunnel 0
Tunnel0 current state: UP
Line protocol current state: UP
Description: Tunnel0 Interface
The Maximum Transmit Unit is 1456
Internet Address is 10.1.2.2/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 2001::2:1, destination 2002::1:1
Tunnel protocol/transport GRE/IPv6
GRE key disabled
Checksumming of GRE packets disabled
Last clearing of counters:
Last 300 seconds input:
Last 300 seconds output:
10 packets input,
0 input error
10 packets output,
0 output error
# From Switch B, you can ping the IP address of VLAN-interface 100 on Switch A.
[SwitchB] ping 10.1.1.1
PING 10.1.1.1: 56
Reply from 10.1.1.1: bytes=56 Sequence=1 ttl=255 time=3 ms
Reply from 10.1.1.1: bytes=56 Sequence=2 ttl=255 time=2 ms
Reply from 10.1.1.1: bytes=56 Sequence=3 ttl=255 time=2 ms
Reply from 10.1.1.1: bytes=56 Sequence=4 ttl=255 time=2 ms
Reply from 10.1.1.1: bytes=56 Sequence=5 ttl=255 time=3 ms
Never
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
840 bytes
840 bytes
Never
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
840 bytes
840 bytes
data bytes, press CTRL_C to break
194