Bosch GWH-635-ES User Manual
Hide thumbs
Also See for GWH-635-ES:
- User manual (20 pages) ,
- User manual (16 pages) ,
- Manual (39 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Bosch GWH-635-ES
Summary of Contents for Bosch GWH-635-ES
- Page 1 Bosch Remote Control for GWH-635-ES...
-
Page 2: Table Of Contents
Contents Contents Caution: remote control is waterproof and can Declaration of also be used in the Conformity FCC shower . Ne- vertheless, should ensure it is Remote Control Data immersed water, for instance in the bathtub Parts supplied Declaration of Conformity FCC Using the Remote Control... -
Page 3: Remote Control Data
Remote Control Data Remote Control Data Support PCB’s connection cable Remote control temperature Using the Remote adjustment of Bosch water heaters GWH-635-ES. Control Technical Data: Description of the LCD Battery power Alkaline LR 6 supply 2 x 1,5V Frequency 915 MHz... - Page 4 Using the Remote Control Remote control trans- Remote control transceiver PCB installation ceiver PCB installation B Open control box top cover (Fig. 3, Warning: pos. 1). safety reasons, B Remove the protective cover (Fig. 3, disconnect pos. 2) from one face of the support power supply to the and fix it to the main PCB as shown heater.
- Page 5 Using the Remote Control • the control box in the appliance • all connections between the PCB and the appliance • lower cover in the control box • holding bracket • front cover panel. Remote Control Activa- tion Before remote control will work it will have to be activated, Fig.
- Page 6 Using the Remote Control (tolerance from selected set point -5 The rotating digit shows that the + 3 °K). electronics is expecting a registration. B Hold remote control in front of the control panel on the heater and press simultaneously remote control buttons until the temperature indication is shown on...
- Page 7 Using the Remote Control control (Fig. 7, pos. 3) pressed for 3 If the temperature was memorized seconds. using remote control buttons (it is possible to combine up to six remote controls), it can only be modified whilst hot water is flowing if the same remote control is used again (see chapter 4.6 "Priority Function").
- Page 8 Using the Remote Control "Priority" function the control panel or the remote control was used). Temperature cannot be The "Priority" function ends: memorized or selected • 5 minutes after the last use of the using the control panel hot water (return to basic set up). buttons even •...
-
Page 9: Maintenance
Maintenance indicated by an error code that will Warning: flat bat- appear on the display (Fig. 2, pos. 1) teries must and by a symbol indicating a "safety replaced. block" (Fig. 2, pos. 7). The device will Consequently, be operative once again following the manufacturer is not elimination of the fault and after liable for any faults or... - Page 10 Maintenance 6 720 606 990...
- Page 11 Maintenance 6 720 606 990...