Table of Contents
Advertisement
4
Press <Ait> <F>
.
The system displays a menu in the upper left comer of the
screen.
5
Press <X> to
exit.
6
Press <Y> to save your edits
.
7
Reboot the
machine,
and proceed to section 8 to install MS-DOS
CD-ROM Extensions software.
8.
Install the MS-DOS CD-ROM Extensions Software
12
The MS-DOS CD-ROM Extensions software enables your CD drive to read
compact discs formatted under the ISO or High Sierra
standards.
Follow
the procedures here to install this software on your hard-disk
drive.
1
Reboot your workstation with MS-DOS
3.
1 or
later.
2
Insert the MS-DOS CD-ROM Extensions diskette in drive
A.
3
Type
a: and press <Enter>
.
4
Type
setup and press <Enter> to start the Setup Program
.
Note
The Setup Program locates all filenames on the default drive with a
.SYS
extension.
Only two such files are included on the MS-DOS CD-
ROM Extensions diskette.
If
you mistakenly start the Setup Program
on a diskette drive while operating from a different default drive (by
typing
a: setup as a single command in steps 3 and
4),
you may get a
long list of .SYS files that the Setup Program asks
if
you want to install.
The title screen displays and the program tells
you:
The following CD-ROM device drivers were found:
HITACHIA.SYS size
xxxxx
bytes
HITACHIB .SYS size
xxxxx
bytes
It
then asks:
Answer which of the following device drivers do you want to install?
Do you want to install HITACHIA.SYS? [Y or N]
5
Press <Y> for "yes.
"
Next, the program asks
:
How many drives would you support (1->8}
(Press RETURN for default)
N:1
[Default]
N:
6
Press <Enter> to accept the default value of one, or enter the num-
ber of CD drives you have and press <Enter>.
The program then
asks:
If you would set
1/0
address, please input address
<address values> 200
,
220, 240
,
260, 300, 320
,
340
,
360
(Press <Enter> for default}
P:300
[Default]
P:
Hitachi
3700
CD Drive Installation Instructions
•
•
•
Advertisement
Table of Contents
