Pushbuttons And Leds - Electrolux WMD1050 Service Manual

Pushbuttons and LEDs

The functions of each button are defined by the configuration of the appliance.
•
Button 1: This pushbutton is connected to two LEDs (11 – 12) and, if used, may
be configured for selection of one or two options; in the latter case, the two
options cannot be selected at the same time.
•
Buttons 2, 3, 4: These buttons are connected to LEDs 21, 31 and 41
respectively and, if used, each can be configured for a single option.
•
Button 5: This button can be configured in two ways:
→ as a single option: in this case, the button is connected to LED 51
→ as a multi-selection button: in this case, the button is connected to LEDs 61,
62, 63, 64, 65, and can be used to select the spin speed and the delayed-start
time. However, one of the LEDs must be configured as an END OF CYCLE
signal; therefore not all the LEDs are used by this button.
•
Combination of buttons: The appliance can be configured to utilize a combination of two buttons
(which must be pressed simultaneously for 5 seconds) to select the super-rinse cycle or to deactivate
the buzzer (if featured). A similar procedure is used to access the diagnostics procedure or to select
DEMO mode.
Wash phase LEDs
LEDs 61-65 can be used as wash phase indicators, in which case they are not
associated with button 5.
These, too, can be configured; the END OF CYCLE indicator is featured on all models.
Pre-wash
Wash
Pre-wash/Wash
Rinses
Spin
Drain
Extra rinse
Rinse-hold
Current cycle
End of cycle
ON/OFF
Door locked
Indications
Lights during selection mode if the programme includes the pre-wash phase,
and during the execution of the pre-wash
Lights during selection mode if the programme includes the wash phase, and
during the execution of the wash
Lights during selection mode if the programme includes the pre-wash or wash
phases, and during the execution of these phases
Lights during selection mode if the programme includes rinse phases, and during
the execution of the rinses
Lights during selection mode if the programme includes the spin phase, and
during the execution of the spin
Lights during selection mode if the programme includes the drain phase, and
during the execution of the drain
Lights when this option has been memorized (if included in the cycle)
Lights if the programme includes the rinse-hold option and at the end of the
cycle, when the appliance stops with water in the tub
Lights during execution of the cycle
Lights when the programme has been completed; also used to display alarm
conditions
Lights when the appliance is switched on
Lights when the door interlock prevents opening of the door, and switches off
when the door can be opened. Flashes when the interlock is about to release the
door (may be seen if PTC devices are used, as these require one or two minutes
before releasing the interlock)
7