Table of Contents
Advertisement
1. Locate, record, and retain the product switch information in order to configure and
2. Attach front mounting brackets (Item 1) and rear mounting brackets (Item 6) to
3. From the front, slide the switch into the rack at the desired height.
4. Secure the switch to the front rack posts with M6 screws (Item 3), and clip nuts
48
NE1032T Installation Guide
To install the NE1032T in an iDataPlex rack, complete the following steps:
register your product. See "Before Installing the NE1032T" on page
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch and
affix the new label to the bottom of the new switch.
each side of the switch with M4 screws (Item 2). Torque the screws to
approximately 2 newton‐meters (Nm) +/‐ 0.1 Nm (17.7 inch‐pounds).
(Item 4). Torque the screws to approximately 5.7 Nm +/‐ 0.1 Nm (50 inch‐pounds).
4
3
1
2
34.
6
Hide quick links:
Advertisement
Table of Contents
