Shift - Hitachi DV 14DCL2 Service Manual

Fig. 9
Position of Spring (A) [16]
and Steel Ball D5 [17]
(c) Mount the Shift Arm [24] into the groove of the Rear Case [22] reassembled in step (b) above.
Facing the ridge of the Shift Arm [24] toward the Motor [36] side, mount the Shift Arm [24] on the
unmarked side of the assembly that was reassembled in step (b) above. Then insert the protrusions of
the Shift Arm [24] into the holes of the Rear Case [22] and make sure that the protrusions fit into the
grooves of the Slide Ring Gear [25] mounted in the Rear Case [22]. (See Fig. 11.)
Fig. 11
Ridge
Groove
C
(d) Mount the Drill Chuck 13VLRS-N [2].
Mount the Drill Chuck 13VLRS-N [2] by using the special repair tool (J-348, Code No. 349-886), and
then secure it with Flat Hd. Screw (A) (Left Hand) M6 x 25 [1].
(e) Mount the Shift Knob [37] onto the assembly that was reassembled in step (d) above.
When mounting the Shift Knob [37] to the Shift Arm [24], check that the "LOW" mark on the Shift Knob
[37] faces the Motor [36] with the Shift Arm [24] fitted into the recess of the Shift Knob [37].
Hole
Fig. 10
Recesses
View of C
Mark
-7-
Recess
Recess