4
Disassembly/Assembly > Controller System > Removing the Primary Transfer High-voltage PCB Unit > Procedure
NOTE: Actions after assembly
Execute Auto Adjust Gradation.
Settings/Registration > Adjustment/Maintenance > Adjust Image Quality > Auto Adjust
Gradation > Full Adjust
4
Disassembly/Assembly > Controller System > Removing the Primary Transfer High-voltage PCB Unit > Procedure
Removing the Primary Transfer High-voltage PCB Unit
■ Preparation
1) Removing the ITB Unit(Refer to page 4-112).
2) Removing the Waste Toner Container(Refer to page 4-108).
3) Removing the Drum Unit (Y/M/C/Bk)(Refer to page 4-109).
4) Remove the Rear Cover 1(Refer to page 4-34).
5) Remove the Left Lower Cover(Refer to page 4-36).
■ Procedure
1) Remove the Drum Unit Suction Cooling Fan [1].
• 1 Connector [2]
• 1 Claw [3]
• 2 Hooks [4]
4-90
F-4-215
4-90