5.6.6 Dynamic Host Configuration Protocol (DHCP) Assignment
5.6.6 Dynamic Host Configuration Protocol (DHCP) Assignment
Description
It is possible to assign this PBX as a Dynamic Host Configuration Protocol (DHCP) client, allowing IP addresses
to be received from a DHCP server over a LAN.
Conditions
•
It is possible to enable this feature through system programming.
Notice
It is important to set your DHCP server to not change the IP addresses of the mother board and DSP cards
once IP telephones are registered to the PBX. The IP telephones will not operate properly if these IP
addresses are changed.
PC Programming Manual References
27.1 Network Service—[1] IP Address/Ports—DHCP Server
→
LAN Setting—Obtain an IP address automatically/Use the following IP address
→
LAN Setting—IP Address
→
DSP IP Setting—Obtain DSP IP address automatically/Use the following DSP IP address
558
Feature Guide