Specific Service Instructions; Disassembly; Removing The Top Cover; Removing The Front Panel Assembly - JVC SR-HD1250US Service Manual

This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
Before disassembly, be sure to turn OFF the power and unplug
the power cord.
3.1 Removing the top cover (See Figure 1)
(1) Remove the four screws A attaching the top cover from
both sides.
(2) Remove the three screws B attaching the top cover from
the back.
(3) Remove the top cover by sliding it backward.
Top cover Top cover Top cover
A x 2
A x 2
B
3.2 Removing the front panel assembly (See Figure 2 and
Figure 3)
• Remove the top cover.
(1) Remove the nine tabs on the front panel assembly, and
then remove the front panel assembly.
Tab
Tab
Tab
SECTION 2

SPECIFIC SERVICE INSTRUCTIONS

SECTION 3

DISASSEMBLY

B
Fig.1
Front panel assembly
Fig.2
Front panel assembly
Fig.3
3.3 Removing the HDD (See Figure 4)
• Remove the top cover.
(1) Pull out the SATA cable and the HDD power cable con-
nected to the HDD.
(2) Remove the four screws C attaching the HDD bracket.
(3) HDD is removed from the HDD bracket.
B
HDD Power cable
3.4 Removing the BD drive unit (See Figure 5)
• Remove the top cover.
(1) Pull out the SATA cable and the BD drive power cable con-
nected to the BD drive unit.
(2) Remove the four screws D attaching the drive bracket.
(3) The rear side of the BD drive unit is lifted a little and re-
moved.
(4) Drive bracket is removed from the BD drive unit.
SATA Cable
Tab
D BD Drive unit
SATA Cable
Fig.4
BD Drive power cable
D
Fig.5
(No.YD125<Rev.001>)1-5
C
HDD
C