Dldp Interval - HP A3100-8 v2 SI Command Reference Manual

View
System view, Layer 2 Ethernet port view, port group view
Default level
2: System level
Parameters
None
Description
Use the dldp enable command to enable DLDP.
Use the undo dldp enable command to disable DLDP.
When executed in system view, these two commands take effect globally. When executed in layer 2
Ethernet port view, these two commands take effect on the current port. When executed in port group
view, these two commands take effect on all the ports in the port group.
DLDP can take effect only after you enable it globally and then on a port.
By default, DLDP is disabled both globally and on each port.
Examples
# Enable DLDP globally, and then enable DLDP on GigabitEthernet 1/0/25.
<Sysname> system-view
[Sysname] dldp enable
[Sysname] interface gigabitethernet 1/0/25
[Sysname-GigabitEthernet1/0/25] dldp enable
# Enable DLDP globally, and then enable DLDP for all the ports in port group 1.
<Sysname> system-view
[Sysname] dldp enable
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/25 to gigabitethernet
1/0/26
[Sysname-port-group-manual-1] dldp enable

dldp interval

Syntax
dldp interval time
undo dldp interval
View
System view
Default level
2: System level
Parameters
time: Specifies the interval for sending Advertisement packets, in the range 1 to 100 seconds.
Description
Use the dldp interval command to set the interval for sending Advertisement packets.
25