Controller Settings - Cisco 7925G Series Deployment Manual

For the autonomous access point, ensure that the SSID is configured for open + eap as and network-eap when using 802.1x
authentication.
As of the 1.3(2) release, the Cisco Unified Wireless IP Phone 7925G Series utilizes open + eap when doing 802.1x
authentication, but utilized network-eap in previous releases.
dot11 ssid voice
vlan 21
authentication open eap
authentication network-eap
authentication key-management wpa cckm
admit-traffic
If the autonomous access point is registered to a WDS (Wireless Domain Services) server, ensure both leap and eap types of
authentication are enabled in the WDS configuration.
wlccp authentication-server infrastructure method_Infrastructure
wlccp authentication-server client mac method_Clients
wlccp authentication-server client
wlccp authentication-server client
wlccp wds priority 255 interface BVI1

Controller Settings

In releases prior to 6.0, Aggressive Load Balancing was configured in the General Controller settings.
In 6.0 and later, this is referred to as Client Load Balancing and is configurable under the WLAN configuration (SSID
settings).
Cisco Unified Wireless IP Phone 7925G Series Deployment Guide
eap_methods
eap_methods
eap method_Clients
leap method_Clients
53