Poe Configuration Example - HP A3100-8 v2 EI Configuration Manual

To do...
Display the information of PSE
Display all information of the
configurations and applications of
the PoE profile
Display all information of the
configurations and applications of
the PoE profile applied to the
specified PoE interface

PoE configuration example

Network requirements
As shown in
Ethernet 1/0/1, Ethernet 1/0/2, and Ethernet 1/0/3 are connected to IP telephones.
•
• Ethernet 1/0/1 1 and Ethernet 1/0/12 are connected to APs.
The power supply priority of IP telephones is higher than that of the APs, for which the PSE supplies
•
power to IP telephones first when the PSE power is overloaded.
The maximum power of AP 2 connected to Ethernet 1/0/12 does not exceed 9000 milliwatts.
•
Figure 30 Network diagram for PoE
Configuration procedure
# Enable PoE on Ethernet 1/0/1, Ethernet 1/0/2, and Ethernet 1/0/3, and set their power supply
priority to critical.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] poe enable
[Sysname-Ethernet1/0/1] poe priority critical
[Sysname-Ethernet1/0/1] quit
[Sysname] interface ethernet 1/0/2
[Sysname-Ethernet1/0/2] poe enable
[Sysname-Ethernet1/0/2] poe priority critical
Figure 30,
Use the command...
display poe pse [ | { begin |
exclude | include }
regular-expression ]
display poe-profile [ index index |
name profile-name ] [ | { begin |
exclude | include }
regular-expression ]
display poe-profile interface
interface-type interface-number [ |
{ begin | exclude | include }
regular-expression ]
80
Remarks