Multi Room Setup; 12 Volt Trigger Setup - Pioneer Elite VSX-52TX Operating Instructions Manual

Other Settings

Multi Room Setup

• Default setting: VARIABLE / Setting 1
If you've made multi-room connections (see Multi-room
listening on page 58) you may need to specify your
volume setting and IR receiver type.
1 Select 'Multi Room Setup' from the Other Setup
menu.
6. Other Setup
[ a . DRC Setup
[ b . Dual Mono Setup
[ c . LFE ATT Setup
[ d . SR+ Setup
[ e . Multi Room Setup
[ f . 12V Trigger Setup
2 Select the volume level setting.
6e. Multi Room Setup
Volume Level
[ VARIABLE ]
IR Setting
[Setting 1]
CAUTION:If the "FIXED"
position is chosen, the
volume will be loud.
• VARIABLE – Use this setting if you've connected a
power amplifier in the sub room (this receiver is
simply being used as a pre-amp) and you will be
using this receiver's controls to adjust the volume.
• FIXED – Use this setting if you've connected a fully
integrated amplifier (such as another Pioneer VSX
receiver) in the sub room and want to use that
receiver's volume controls.
Caution
• With the FIXED setting, the source is sent from this
receiver at maximum volume, so make sure the
volume is quite low in the sub room at first and then
experiment to find the correct level.
3 Select the type of IR receiver you're using.
6e. Multi Room Setup
Volume Level
IR Setting
• Setting 1 – Use this setting for most IR receivers.
• Setting 2 – Use this setting if the IR receiver you're
using doesn't seem to work after selecting Setting 1.
4 When you're finished, press RETURN.
You will return to the Other Setup menu.
]
]
]
]
]
]
6f. Multi Room Setup
Volume Level
[ FIXED ]
IR Setting
[Setting 1]
CAUTION:If the "FIXED"
position is chosen, the
volume will be loud.
[ VARIABLE ]
[ Setting 1 ]
Note
• Some IR receivers may not work with this receiver.
Check with your audio dealer for more information.

12 Volt Trigger Setup

• Default setting: OFF (all components)
After connecting a component the 12 volt trigger (see
Switching components on and off using the 12 volt trigger
on page 62), it switches on automatically when you select
an input function set to switch the trigger on. Specify
which input functions switch on the trigger below.
1 Select '12V Trigger Setup' from the Other Setup
menu.
6. Other Setup
[ a . DRC Setup
[ b . Dual Mono Setup
[ c . LFE ATT Setup
[ d . SR+ Setup
[ e . Multi Room Setup
[ f . 12V Trigger Setup
2 Select an input function and choose the setting
that you want.
This should be the input function, that when selected,
switches on the 12 volt trigger.
6f. 12V Trigger Setup
DVD/LD [ OFF ]
TV/SAT [ OFF ]
DVR [ OFF ]
VIDEO1 [ OFF ]
VIDEO2 [ OFF ]
TUNER [ OFF ]
CD-R [ OFF ]
CD [ OFF ]
• OFF – 12 volt trigger is not activated for the selected
component.
• ON – 12 volt trigger is activated for the selected
component.
3 Repeat for as many input functions as you would
like to set.
4 When you're finished, press RETURN.
You will return to the Other Setup menu.
]
]
]
]
]
]
6f. 12V Trigger Setup
DVD/LD [ ON ]
TV/SAT [ OFF ]
DVR [ OFF ]
VIDEO1 [ OFF ]
VIDEO2 [ OFF ]
TUNER [ OFF ]
CD-R [ OFF ]
CD [ OFF ]
11
67
En