Attaching/Detaching The Pioneer Stand - Pioneer PDP-5080HD Operating Instructions Manual

Preparation
05

Attaching/detaching the Pioneer stand

The plasma display comes with the Pioneer table top stand
attached. You can also install the display on a rack by detaching
the stand. The method for attaching/detaching the stand varies
depending on the product.
Caution
• This product can be used only with the attached stand. Using
other stands can result in instability, possibly causing injury.
• The weight of a 50 inch plasma display is about 34.8 kg (76.7
lbs.) and a 42 inch about 29.9 kg (65.9 lbs.), it has no depth, and
is unstable. Therefore, at least two people must assemble and
install it.
Detaching the stand
• When removing the stand before you install the speaker,
begin with step 2 (for PDP-5080HD).
• Begin with step 2 for PDP-4280HD.
• Besides the speaker, steps for detaching the stand are the
same for PDP-5080HD and PDP-4280HD. Illustrations
shown are for PDP-5080HD.
1
Detach the supplied speaker if it has already been
installed.
• To detach the speaker, remove the cable wiring for the
speaker at the rear and screws at the rear of the speaker
and pull it out (see step 3 on page 18).
• Use the protective sheet in which the speaker was
wrapped between the speaker and stand.
• Make sure to remove the speaker mounting fittings.
22
En
2
With the plasma display lying flat, loosen and remove
the two installation bolts (1) and (2) using a
screwdriver.
Installation bolts (1): M8 x 23 mm (black) for PDP-4280HD
M8 x 23 mm (black) for PDP-5080HD
Installation bolts (2): M8 x 60 mm (black) for PDP-4280HD
M8 x 40 mm (black) for PDP-5080HD
Table top stand
Sheet
3
Remove the stand from the plasma display.
Note
• Make sure to keep the installation bolts (1) and (2) that have
been removed as they are re-used when attaching the stand to
the plasma display.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma display lying flat on a table or similar
surface.
• When lying the plasma display down, be careful not to scratch
or damage it.
Installation bolts (1) (Step 1)
Installation bolts (2) (Step 2)