Step 1.3 Drilling A Hole Through The Wall - Samsung AC***MNADKH Installation Manual

Preparation
ACMNTDEH
Installation plate (1)
100
Remote control battery (2)
Installation Manual (1)
M4 x 16
Tapped Screws (2)
Tools
General tools
• Vacuum pump
(Backward flowing
prevention)
• Manifold gauge
• Stud finder
• Torque wrench
• Pipe cutter
B C
• Reamer
Tools for test operation
• Thermometer
• Resistance meter
• Electroscope
6 English
Remote control (1)
User Manual (1)
Remote Control Holder (1)
• Pipe bender
• Spirit level
• Screwdriver
• Spanner
• Drill
• L-wrench
B
• Measuring tape
Step 1.3 Drilling a hole through the
wall
Before fixing the installation plate to a wall and then fixing
the indoor unit to the installation plate, a window frame,
or a gypsum board, you must determine the position of a
hole (with 65 mm inner diameter) through which the pipe
bundle (consisting of power and communication cables,
refrigerant pipes, and drain hose) will pass and then drill
that hole.
1 Determine the position of a 65 mm hole in
consideration of the possible directions of the pipe
bundle and the minimum distances between the hole
and the installation plate.
Left
<Possible directions of the pipe bundle>
CAUTION
• If changing the pipe direction from left to right, do not
drastically bent it but slowly turn it in the opposite
direction as shown. Otherwise, the pipe may be
damaged in the process.
C B
<Minimum distances between the hole and the
installation plate>
Model
AC026MNADKH
AC035MNADKH
AC052MNADKH
AC071MNADKH
Right
Rear right or left
Bottom right
Pipe bundle hole
C
(Unit : mm)
A B C D
36 60 65 36
36 190 81 36
33 110 110 33
Pipe bundle hole: Ø 65 mm