Controlling Combo Devices - GE 33711 Instruction Manual

A B
Programming Your Remote
Did the device turn off?
• If YES, you have found a code for the
device. Press and release the same device
button you pressed in Step 3. This will
store the code in the remote. Go to step 7.
• If NO, continue to press and release the
list
VOL + button until the device turns off to
test the other 9 codes from Step 4.
Be sure to wait approximately 3 seconds
after each VOL + button press to allow
the device time to respond to the code.
When the device turns off, you have
found a code for your device. Press and
release the same device button pressed
in Step 3. This will store the code in the
remote. Go to Step 7.
7. Use the remote to turn the device back on.
tv cbl
8. Repeat this process for each device you wish
to control.
menu
A B

Controlling Combo Devices

Some combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR,
etc.) will require you to set up two different device
buttons to control both parts of the combo device.
For example, if you have a TV/DVD combo, you may
need to set up one code under the TV button to
control the TV and a separate code under the b-ray
button to control the DVD.
list
C D
exit
Notes:
• The VOL – button can be used to go backwards
through each batch of 10 codes.
• The red indicator light will flash 2 times after testing
the first or last code in each batch of 10.
enter
Test the buttons on the remote to see if
the device responds as you would expect.
input
If the buttons do not operate the device,
return to Step 2 and repeat this process to
dvd aux
search for a better code to operate
the device.
setup
C D
exit
9