One-Touch Turn Signal; Wiper Operation - Honda ODYSSEY 2018 Owner's Manual

VEHICLE CONTROLS
Your vehicle
If a vehicle is detected ahead of you, the headlights stay in low beams. If the
system does not detect any vehicles ahead of you, the headlights change to
high beams.
Certain conditions, such as weather and brightness of other vehicles' lights,
can affect system operation.
Turning the System On or Off
n
Make sure the headlight lever is in
the low beam position with the switch
rotated to the AUTO position. The
auto high-beam system indicator
illuminates when the system is on.
The system cancels temporarily when
you drive continuously at speeds
below 45 mph (72 km/h), the vehicle
speed is below 30 mph (48 km/h), or
the windshield wipers run at high
speed for more than a few seconds.
To disable the system: When the vehicle is on and parked, pull the headlight
lever towards you and hold it for 40 seconds. The auto high-beam indicator
blinks once after 30 seconds and again at 40 seconds.
To re-enable the system: Pull the headlight lever towards you and hold it for
30 seconds. The auto high-beam indicator will blink once.
To temporarily disable operation, do either of the following:
• Flash the high beams by moving the lever toward you. Flash the high
beams again to resume auto high beam operation.
• Engage high beams by moving the lever into the high beam position.
Return the stalk to the low beam position to resume auto high beam
operation.
If you find the timing of the beam changes inconvenient for driving, change
the beams manually.
42 |
Oncoming vehicle
Vehicle ahead of you
Headlight Switch
For the system to work properly:
• Do not place an object that reflects light on the dashboard.
• Keep the windshield around the camera clean. When cleaning the
windshield, be careful not to apply windshield cleanser to the camera
lens.
• Do not attach an object, sticker, or film in the area around the camera.
• Do not touch the camera lens.
If the camera receives a strong impact or requires repair, consult a dealer.
If you see the message, "Some Driver Assist Systems Cannot Operate:
Clean Front Windshield," park your vehicle in a safe place. Wipe away
debris blocking the windshield, then start driving again. If the message
remains even after driving for a while with a clean windshield, have your
vehicle checked by a dealer.
If you see a message that the camera is too hot, use the climate control
system to cool the interior. Defroster mode will direct airflow toward the
camera.

One-Touch Turn Signal

Use this quick and convenient method
to signal a lane change.
Lightly push the turn signal lever up or
down for a three-blink sequence.
For a continuous signal, push the lever
up or down until it locks into place.

Wiper Operation

The windshield wipers and washers can be used when the vehicle is on.
Front Wipers
n
Move the wiper lever up or down to the desired position.
VEHICLE CONTROLS
Right Turn
Left Turn
MIST
OFF
INT : Low speed intermittent
*1
: Automatic
AUTO *2
Pull to use
intermittent operation
washer.
LO: Low speed wipe
HI: High speed wipe
| 43