Display Check; Manual Test; Factory Preset - Yamaha RX-V595 Service Manual

No.6 DISPLAY CHECK
Check program for FL display. The display status will change as follows with submenu operation. The signal is
processed with EFFECT OFF.
6 DVD/LD DISP CHECK
Initial displayed.
All segments are turned on and off to detect defects in the FL driver and FL display segments. Then the FL driver
operation is checked by the dimmer control.
Finally, all segments are turned on and off alternately (in lattice form), to check for a short-circuit between adjacent
segments.
No.7 MANUAL TEST
The noise generator built into the DSP outputs test noise from the channel specified by the submenu.
7 DVD/LD TEST ALL
7 DVD/LD TEST MAINR
7 DVD/LD TEST LFE
No.8 FACTORY PRESET
The menu is used to reserve whether or not to set the back-up data for the effect level, delay time and so on to the
factory preset state. The Signal is processed with EFFECT OFF.
8 DVD/LD PRESET INH
8 DVD/LD PRESET RES
Caution : Before setting to the PRESET DATA, write down the existing preset memory contents of the Tuner in a table as
shown below. (This is because setting to the PRESET DATA will cause the memory contents to be as factory set,
i.e., all the preset memory by the user will be erased.)
Page P1
A
B
C
D
E
All segments are turned off
6 DVD/LD 9807150942
Release date displayed.
7 DVD/LD TEST MAINL
7 DVD/LD TEST REARR
1. INHIBIT: The back-up data is not initialized. To keep the data set
by the user, check that this mode has been selected
and cancel the self diagnosis function.
2. RESERVED: When the self diagnosis function is canceled, the back-
up data is initialized to the factory preset state. For the
contents of the initialization, refer to page 20.
The protection data is also reset.
P2 P3 P4
All segments are turned on
Segments ON in a lattice.
7 DVD/LD
7 DVD/LD
P5 P6 P7
RX-V595/R-V905/RX-V595RDS
TEST CNTR
TEST REARL
P8
16