Adjustment - JVC KD-G140J Service Manual

Hide thumbs Also See for KD-G140J:

4.1

Adjustment method

Test instruments required for adjustment

(1) Digital oscilloscope (100MHz)

(2) Electric voltmeter

(3) Digital tester

(4) Tracking offset meter

(5) Test Disc JVC :CTS-1000

(6) Extension cable for check

EXTGS004-26PL x 1

Standard volume position

Balance and Bass &Treble volume : lndication"0"

Loudness : OFF

How to connect the extension cable for adjusting

Caution:

Be sure to attach the heat sink and rear bracket onto the power amplifier IC and regulator IC respectively, before supply the power.

If voltage is applied without attaching these parts, the power amplifier IC and regulator IC will be destroyed by heat.

1-24 (No.MA372<Rev.002>)

SECTION 4

ADJUSTMENT

Standard measuring conditions

Power supply voltage DC14.4V(10.5 to 16V)

Load impedance 20K.(2 Speakers connection)

Output Level Line out 2.5V (Vol. MAX)

Dummy load

Exclusive dummy load should be used for AM,and FM. For FM

dummy load,there is a loss of 6dB between SSG output and

antenna input.The loss of 6dB need not be considered since

direct reading of figures are applied in this working standard.

Extension cable

EXTGS004-26PL

Table of Contents