Display Radio Test Mode (Models Ii/Iii); Entering Display Radio Test Mode; Table 5. Initial Equipment Control Settings; Table 6. Front-Panel Access Test-Mode Displays - Motorola ASTRO XTS 5000 I Basic Service Manual

Performance Checks
Display Radio Test
Mode (Models II/III)
Entering Display Radio
Test Mode
Name of Display
" "
SERVICE
Host Software Version
DSP Software Version
EMC Secure Version
Encryption Type 1
Encryption Type 2
Model Number
14

Table 5. Initial Equipment Control Settings

System Analyzer
Monitor Mode: Standard*
Receiver Checks
RF Control: GEN
Output Level: -47 dBm
Modulation: 1kHz tone
@3kHz deviation
Frequency: Set to selected
radio RX frequency
Meter: AC Volts
Transmitter Checks
RF Control: MONITOR
Frequency: Set to selected
radio TX frequency
Meter: RF Display
Modulation Type: FM
Attenuation: 20 dB
* Use "PROJ 25 STD" if testing ASTRO Conventional channels.
1. Turn the radio on.
2. Within 10 seconds after "SELF TEST" is complete, press Side
Button 2 five times in succession.
3. The radio will show a series of displays that give information
regarding various version numbers and subscriber specific
information. The displays are described in Table 6.

Table 6. Front-Panel Access Test-Mode Displays

Description
The literal string indicates the radio has entered test
mode.
The version of host firmware is displayed.
The version of DSP firmware is displayed.
Version of the encryption hardware
Type of encryption being used
Type of encryption being used
The radio's model number, as programmed in the
codeplug
Test Set
Spkr/Load: Speaker Voltage: 7.5Vdc
PTT: OFF (center) DC On/Standby: Standby
Meter Out: RX Volt Range: 10Vdc
Opt Sel: ON Current: 2.5 Amps
Always
Always
Always
When the radio is secure equipped
When the radio is secure equipped
When the radio is secure equipped
Always
Power Supply
Appears