The following unpacking information is for use by your on the place which reaches a small child's hand. It will KENWOOD dealer, an authorized KENWOOD service center, or the become a cause of suffocation if it wears fl atly. factory.
CONTROLS AND FUNCTIONS Front Panel ■ STATUS 3 4 5 6 7 8 VOLUME MON TAKE OVER DISABLE CTRL OCXO BUSY POWER MICROPHONE OFF/ a Speaker i TX indicator Lights red while transmitting. b CH/STATUS Display Two 17-segment digits display the channel number, name, j BUSY indicator or status.
Page 4
Addendum Terminal Description Control I/O (D-SUB 25 Pin) CONNECTOR MIC (Modular Jack) Pin Name Description Specifi cation Notes Pin Name Description Specifi cation Notes Not used Not used − Not used Not used − Asynchronous Receive Data Comform to RS-232C standard Power Output 13.6 V −...
Page 5
MANDATORY SAFETY INSTRUCTIONS TO INSTALLERS AND USERS • Use only manufacturer or dealer supplied antennas. • Antenna Minimum Safe Distance: 180 cm (6 feet). • Antenna Gain: 0 dBd referenced to a dipole. The Federal Communications Commission has adopted a safety standard for human exposure to RF (Radio Frequency) energy which is below the OSHA (Occupational Safety and Health Act) limits. • Antenna Mounting: The antenna supplied by the manufacturer or radio dealer must not be mounted at a location such that during radio transmission, any person or persons can come closer than the above indicated minimum safe distance to the antenna, i.e. 180 cm (6 feet). • To comply with current FCC RF Exposure limits, the antenna must be installed at or exceeding the minimum safe distance shown above, and in accordance with the requirements of the antenna manufacturer or supplier. • Vehicle installation: The antenna can be mounted at the center of a vehicle metal roof or trunk lid, if the minimum safe distance is observed. • Base Station Installation: The antenna should be fixed-mounted on an outdoor permanent structure. RF Exposure compliance must be addressed at the time of installation.