Brother ADS-2600W Service Manual page 90

(7) Open the upper chute from the panel ASSY.
(8) Remove the taptite cup S M3x6 screw to remove the earth harness (BL), and then pull out
the earth harness (BL) from the hole on the upper chute.
(9) Remove the two panel harness holders, and disconnect the panel PCB harness from the
panel PCB ASSY, and then pull out the panel PCB harness from the hole on the upper
chute.
(10) Disconnect the document detection sensor harness, the document scanning position
sensor harness and the double feeding sensor harness (Sent) from the key PCB ASSY.
Document scanning
position sensor harness
Double feeding sensor
harness (Sent)
Document detection
sensor harness
Key PCB ASSY
Panel ASSY
HARNESS ROUTING: Refer to
Assembling Note:
• Make sure that there is no slack in the panel PCB harness when reconnecting it.
Taptite cup S M3x6
Panel harness holders
Fig. 3-20
"2. Panel PCB ASSY".
3-24
Earth harness (BL)
Panel PCB harness
Hole
Upper chute
Confidential