Hookups With A Cable Box - Philips VPZ210AT Owner's Manual

VPZ210/VPZ215 4/3/99 3:16 PM

8 Hookups With a Cable Box

This connection allows you to view any channel. After you connect the Cable Box, VCP, and
TV as shown below, the features described on this page will be available.
1. Connect Cable signal to
IN Jack on Cable Box.
IN
2. Use RF coaxial cable (supplied) to
connect OUT Jack on Cable Box to
ANT(enna) IN Jack on VCP.
Watching TV With the VCP Off
1
Use the TV channel selector to set the TV to the Cable
Box output channel (channel 3 or 4).
2
Select the channel you want to watch at the Cable Box.
Playing a Tape
1
Use the TV channel selector to put the TV on the VCP
output channel (channel 3 or 4, whichever the CH3/CH4
switch is set to).
2
Press the PLAY button to play the tape.
Page 8
OUT
ANT OUT
CH3
CH4
ANT IN
3. Use a second RF
coaxial cable to con-
nect the ANT(enna)
OUT jack on the
VCP to the TV's
ANTENNA IN Jack.
ANTENNA IN Jack
(example only)
Helpful Hint
• With this hookup, channels cannot
be selected at the TV. You must
select channels at the Cable Box.
Back of TV