Fujitsu AUXB04GALH Service Manual page 11

1-2-3 Automatic address setting for signal amplifiers
When setting the address of the signal amplifier,
please use the factory setting.
(See the installation manual of the signal amplifier)
When the system is normal, nothing will be displayed on
the 7 segment display.
When ERROR is displayed, inspect the units.
Use the "MODE/EXIT", "SELECT",
and "ENTER" buttons on the outdoor unit
Main PCB to configure settings according to the
procedures below.
First 2 digits Last 2 digits
MODE/EXIT
SELECT
SELECT
ENTER
SELECT
ENTER
ENTER
MODE/EXIT
End
Outdoor unit printed circuit board
1: FUNCTION Setting
(the display when the main power is turned on)
(When [F4] to [F9] are displayed, continue to press the "SELECT" button
until [ F3 ] is displayed)
Automatic address setting for
signal amplifiers
Press the "SELECT" button until "10" is displayed
Press the "ENTER" button for more than 3 seconds
*
* Setting is complete when the number of unit is displayed
SWITCH POSITION
01-06
When using signal amplifiers
POWER
ERROR
MODE
LED101 LED102
(GREEN) (RED)
LED105 LED104
MODE
SELECT ENTER
/EXIT
SW107 SW108 SW109
7 Segment
LED Lamp
Push button switch