Cisco AMP8050 Hardware Installation page 66

Error Alert Mode
Table 4-5 Hardware Alarm Error Messages (continued)
Error Message
NFEMessDX
NFEHardware
NFEcount
NMSB_comm
scmd
psls
ftwo
NFE_port18
NFE_port19
NFE_port20
NFE_port21
Use the following procedure to view hardware alert error messages on the LCD display.
To view the hardware alert error messages:
In Error Alert mode, on the HARDWARE ERROR! line, press the right arrow ( ) key to view the
Step 1
hardware errors that triggered the Error Alert mode.
The LCD panel lists the error alert messages starting with the
a list of error messages.
NFEplatformdX
NFEtempX
where
On the error message line, press the down arrow (â) key to view additional errors. When there are no
Step 2
additional errors, the Exit row appears.
Exit
Step 3 Press the right arrow ( ) key to exit Error Alert mode.
If you exit Error Alert mode before you resolve the error that triggered the alert, the LCD panel returns
to Error Alert mode. Contact Support for assistance.
Firepower 8000 Series Hardware Installation Guide
4-10
Condition Monitored
message daemon
hardware status
cards detected
communications
daemon status
scmd
daemon status
psls
daemon status
ftwo
internal link status
indicates the accelerator card (either
X
Chapter 4
Description
Alerts when the message daemon fails.
Alerts when one or more accelerator cards is not communicating.
Alerts when the number of accelerator cards detected on the device
does not match the expected accelerator card count for the platform.
Alerts when the media assembly is not present or not
communicating.
Alerts when the
scmd daemon
Alerts when the
psls daemon
Alerts when the
ftwo daemon
Alerts when the link between the network module switch board and
the accelerator card fails:
81xx Family:
•
NFE_port18
82xx Family and 83xx Family:
, and
NFE_port20 NFE_port21
or ) that generated the alert.
0 1
Using the LCD Panel on a Firepower Device
fails.
fails.
fails.
and only
NFE_port19
,
NFE_port18 NFE_port19
daemon failure followed by
NFE platform
,