Table of Contents
Advertisement
Adjustments
technician following any adjustment or
regulation.
(simmer) must be undertaken only
with burners functioning on natural
gas while in the case of burners
functioning on L.P.G, the screw must
be locked down fully (in clockwise
direction).
burners is unnecessary.
Taps (fig. 21)
All gas taps are male cone type with only
one way of passage. The adjustment
screw (V) is on the side of the stem.
Adjustment of the
position as follows:
on the "Reduced rate" position (small
flame).
attached by simply applying pressure
to the rod.
screw
and turn to the right or left
2
the throttling cone until the flame of
the burner is conveniently regulated
to the Low position, the adjustment
screw
is over (fig. 21) or on the side
2
of the stem .
when the knob is sharply switched
from the "Full on" to "Reduced rate"
positions.
This operation can
be carried out also with the front
panel fitted, but if the technician
finds some difficulties to reach the
adjustment screw, remove the front
panel unscrewing the fixing screws,
which are positioned in the inferior
part of the same.
To tighten some components, see the information
Aluminium pipes to burners, valves,
into
1
4
Fig. 21
Oven thermostat (fig. 22)
carried out in the following way:
the relative knob to the Maximum
position, then wait about 10 minutes.
Minimum position and, using a small
screwdriver
, turn screw
1
right to lower the flame or to the left to
increase it.
The flames must be short for an efficient
Reduced rate setting. They must be stable
to prevent them from accidentally going
out and must be able to stand up to
normal oven door manoeuvres.
1
Fig. 22
ENGLISH
2
1
should be
to the
2
2
Advertisement
Table of Contents
