Setup Utility
Boot Menu
Exit Menu
Parameters
Save Values & Exit
Exit Without Saving Changes
Get Default Values*
Load Previous Values
Save Current Values
* This item may not be displayed when starting up the Setup Utility with the User Password.
<Only when the port replicator is connected>
Floppy Drive
Hard Disk Drive
CD Drive
LAN
The default order is as follows:
[Floppy Drive]
[Hard Disk Drive]
To move a device up by one in the order, select the device with
F6 .
To move a device down by one in the order, select the device with
F5 .
NOTE
[Boot] menu cannot be changed when the Setup Utility is started up with the User
Password.
Boot Menu
The device for starting up the operating system can also be selected during computer
start-up. After the computer is turned on, and Esc is pressed at "Panasonic" boot
screen, [Boot Menu] (the device selection display) will appear. When the setting of
[Boot] menu is changed, the selection screen display will also change. [Boot Menu] is
displayed only when [Boot First Menu] in [Security] menu is set to [Enable].
Save Values & Exit
Exit Without Saving Changes
Get Default Values
Load Previous Values
Save Current Values
Exit the Setup Utility and save your changes to CMOS.
Exit the Setup Utility without saving your changes to CMOS.
Set the default settings.
Load previous values from CMOS for all Setup items.
Save your changes to CMOS.
[CD Drive]
[LAN].
33
and
,and then press
and
,and then press