Other Problems; The Remote Control Does Not Work - Epson EB-L25000U User Manual
Hide thumbs
Also See for EB-L25000U:
- Firmware update (16 pages) ,
- Installation handbook (13 pages) ,
- User manual (231 pages)
Table of Contents
Advertisement
Problem Solving
Check
Do the indicators turn on and off when the power cord is touched? There is probably a poor contact in the power cord, or the power cord may be defective. Reinsert the power cord. If this
Is the Control Panel Lock set to Full Lock?
Is the correct setting for the remote receiver selected?
Was the power cord plugged back in or was the breaker turned on
immediately after direct shutdown?
Is the [ID] switch on the remote control set to On?
Other Problems
The remote control does not work
Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Is the correct setting for the Remote Receiver selected?
does not solve the problem, stop using the projector, disconnect the power cord from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
Press the [
] button on the remote control. If you do not want to use Control Panel Lock, change the setting to
Off.
s "Control Panel Lock"
p.111
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver
p.123
When the operation to the left is performed when Direct Power On is set to On, the power may not turn back on. Press
the [
] button to turn on the power.
When the switch is set to On, you can use the remote control to operate only a projector with a matching ID. Set the [ID]
switch to Off.
s "Setting the remote control ID"
p.38
Point the remote control towards the remote receiver.
s "Remote control operating range"
Check the operating range.
s "Remote control operating range"
Set the projector up in a location where strong light does not shine onto the remote receiver.
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver
p.123
Remedy
Remedy
p.23
p.23
170
Advertisement
Table of Contents
