Selecting Cycles And Options/Startlng Dishwasher - Maytag DWU8750AAE User Manual

Options
Delay Start
You can delay" the start of the Pots & Pans cycle
Temp Roost Sensor up to six hours. To set up a delay, turn the dial to
If for any reason the incoming water the number of hours you would like the Pots &
temperature is below 120°E press tbe On Pans cycle delayed.
button to assure the water is heated to proper
temperature for best cleaning and drying
To Start Dishwasher
results. The dial will pause at the _ to extend After loading set the dial to the desired cycle.
the main wash and the Heating Delay light wilI Press button for desired options.
turn on. NOTE: Run the water from the hot water tap to
Press the Off button to cancel the Temp Boost clear the line of cold water before
Sensor. starting.
Heated Rinse and Dry Options Press the door until it latches. The cycle will
begin with a drain prior to fill and the On
RINSE TEMP indicator will light,
Press the Sani button to turn the heating
element on during all rinses. The Sani option
Indicator Lights
helps maintain water temperature and improve When Delay" Start is selected the Delay Start
drying results, light glows until the cycle begins. The On light
Press the Normal button if Sani is not desired, indicates that the disbwasber is operating. At
the end of the dry phase Clean will remain lit
The heating element will be offin all rinses, until the dial has been advanced to the (_. The
FAN DRY Heating Delay light indicates that the main
Press the Heat button to turn tile heating wash is being extended to heat the water to
element on during the fan dry period. This proper temperature.
option improves drying results. Adding a Forgotten Item
Press the Air button to turn the heating element For best cleaning, the forgotten item should be
off during the fan dry period.Towel dr,ring may added early in the cycle.
be necessary. 1. Unlatch the door and wait until the sound of
NOTE: Temp Boost Sensor, Rinse Temp and circulating water stops.
Fan Dry"options can be used separately
or togetber. 2. Open the door and add the item.
3. Pause before latching the door. The cycle will
continue at the point it was interrupted. I
PAGE 9