Before Requesting Service - Panasonic NU-SC100W Operating Instructions Manual

Before Requesting Service

PROBLEM
Oven will not turn on.
Oven will not start
cooking.
No steam
"U14" appears in the
display window.
"U90" appears in the
display window.
"U50" appears in the
display window.
If it seems there is a problem with the oven, contact an authorized Service Center.
F0003BM03HP_Eng_170306.indd 37
POSSIBLE CAUSE
The oven is not plugged in
securely.
Circuit breaker or fuse is tripped
or blown.
There is a problem with the
outlet.
The door is not closed completely.
Start button was not pressed
after programming.
Another program has already
been entered into the oven.
The program has not been
entered correctly.
Stop / Reset button has been
pressed accidentally.
Check whether the water tank
has water.
Check whether the water tank is
installed correctly in place.
The water tank lacks water.
Do not pour detergent mixture
into the sink of the oven when
using "Evaporating fl ume"
function (Auto menus No. 16).
Or the mixture is less than 30 ml.
Drain Water function has been
used 3 times uninterruptedly.
The cavity is overheated.
- Eng-37 -
REMEDY
Remove plug from outlet, wait 10
seconds and re-insert.
Contact the specifi ed service
center.
Plug another appliance into the outlet
to check if the outlet is working.
Close the oven door securely.
Press Start button.
Press Stop / Reset button to cancel
the previous program and program
again.
Program again according to the
Operating Instructions.
Program oven again.
Fully fi ll the water tank and properly
install it.
The 1 and 2 time when "U14"
st nd
shows in the display window, you
can press Start button to resume
cooking. If "U14" shows a 3
rd
stop cooking, re-fi ll the water tank,
position back in the oven and press
Start button to resume cooking.
Pour 30 ml of detergent mixture into
the sink of the oven. Read P.22 for
details. Press Stop/Reset button
and U14 will disappear. Re-select
the "Evaporating fl ume" (Auto menus
No.16), press Start button and
cleaning will start.
Wait 10 minutes before operating
again.
Operate again after cooling down
and "U50" disappears.
time,
2017/3/6 8:50:53