Clearing Dynamic Addresses From The Mac Table; Enabling Rmac Learning Feature; Verifying The Mac Address Configuration - Cisco Nexus 6000 Series Configuration Manual

Clearing Dynamic Addresses from the MAC Table

Clearing Dynamic Addresses from the MAC Table
Procedure
Step 1
Step 2

Enabling RMAC Learning Feature

Procedure
Step 1
Step 2

Verifying the MAC Address Configuration

Use one of the following commands to verify the configuration:
Table 8: MAC Address Configuration Verification Commands
Command
show mac address-table aging-time
show mac address-table
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
114
Command or Action
switch# configure terminal
switch(config)# clear mac address-table
dynamic {address mac-addr} {interface [type
slot/port | port-channel number} {vlan
vlan-id}
Command or Action
switch# configure terminal
switch(config)# [no] mac address-table
router-mac learn-enable
Configuring MAC Address Tables
Purpose
Enters global configuration mode.
Clears the dynamic address entries from the
MAC address table.
Note If this is a 10G breakout port, the
slot/port syntax is QSFP-module/port.
Purpose
Enters global configuration mode.
Enables/disables the RMAC learning feature.
• You can use the clear mac address-table
dynamic command to clear the learned MAC
addresses.
Purpose
Displays the MAC address aging time for all VLANs
defined in the switch.
Displays the contents of the MAC address table.
Note IGMP snooping learned MAC addresses are
not displayed.