Table of Contents
Advertisement
The external monitor's power cable or data cable is not connected properly
Switch off the external monitor and the notebook.
Check whether the power cable is plugged properly into the power adapter and into the power
outlet.
Check whether the data cable is properly connected to the notebook and the external monitor
(if it is plugged in with a connector).
Switch on the external monitor and the notebook.
The external monitor is blank or the image is
unstable
The wrong frequency has been selected for the external monitor or for the application program.
Terminate the application program in Windows 9x with
program has been terminated, switch the external monitor off, wait for about 5 seconds, and then
switch the external monitor on again.
Set the screen resolution required by the application. Select the Start button. Select the System
control item under Settings. Double-click on the Display symbol. Select the required screen
resolution on the Settings tab of the Resolution field.
The screen display (TV) is black and white
The screen of the TV or video device is connected to the notebook's S-VHS output. Depending on
the device or cable used, automatic switchover between the FBAS and S-VHS TV standards will not
function correctly.
Hold down the key combination
The notebook stops working
If the notebook stops working, this may have the following reasons:
The notebook is in Standby or Suspend mode
Reactivate the notebook by pressing a key (Standby mode) or by switching it back on
(Suspend mode).
An application program has caused the malfunction
Close the application program or restart the notebook by switching it on/off or with a warm
boot.
The battery is dead
Recharge the battery or install a fully charged battery.
A26391-K82-Z101-3-7619
+
until the screen display is correct.
Troubleshooting and tips
. If the error persists after the
+
43
Advertisement
Table of Contents
