Before Calling Service - Philips 32PF7320A Manual

Before Calling Service

Symptoms Items to Check and Actions to follow
•
"Ghost" or
double images
•
No power
•
•
No picture
•
•
•
•
•
No picture and
power switched on
When displaying a High Definition signal from the YPbPr inputs or HDMI input, if necessary, you can adjust
Picture position
the picture position to the center of the screen with the cursor left/right or up/down buttons on the
adjustment
remote control.This may be needed due to slight differences in output signals from different brands and
types of HD sources boxes.
Notes: Most High Definition receiver boxes also have picture-positioning controls in their menu systems. If the TV cursor
controls run out of range before the picture is correctly positioned, the receiver box controls will need to be adjusted.
•
No photo, music
or video play or in
poor quality only
•
No sound
•
•
•
Good sound but poor
color or no picture
•
Snowish picture
and noise
Television not •
responding to •
remote control •
•
•
Control of •
accessory devices
The software will Possibly the operating system is wrong. Go to www.philips.com/support to see which operating
not install systems are supported.
Your TV consumes energy in the standby mode. Energy consumption contributes to air and water pollution.
Standby
No CableCARD installed: 1 W.
Energy Star
With CableCARD installed: 15 W.
Compliance
If your TV has been shutdown in an improper way (e.g. power drop, power cord plug out), starting up
After improper
the TV again will take a longer time than usual.
shutdown
See Extras, Specifications on this CD.
Miscellaneous
This may be caused by obstruction to the antenna due to high rise buildings or hills.
Using a highly directional antenna may improve the picture.
Check that the TV's AC power cord is plugged into the mains socket.
Unplug the television, wait for 60 seconds.
Then re-insert plug into the mains socket and turn on the television again.
Check antenna connections at the bottom of the TV to see if they are properly connected to the TV.
Possible broadcast station trouble.Try another channel.
Adjust the contrast and brightness settings.Try another auto picture setting.
Check the Closed Captions control. Some TEXT modes could block the screen.
Check if you selected the correct AV source.
Your TV has a protective mode in case there is too much heat build-up.
Check the clearance around the vents of the device to be certain there are no blocking walls or cabinets
which would limit the air flow.
Check if the source complies with a supported code.
Increase the VOLUME.
Check that the TV is not muted, press the
When no signal is detected, the TV automatically switches off the sound.
This is proper operation and does not indicate a malfunction.
Adjust the contrast, color, tint and brightness setting.
Try another auto picture setting.
Check the antenna connection.
Check whether the batteries are working. Replace if necessary.
Clean the remote control sensor lens on the monitor.
Operating range between TV and the remote control should not be > 240".
You can still use the buttons on the left side of your TV.
Check if the remote control is in the correct mode.
The infrared signals of the screen may influence the reception sensibility of other peripherals
Solution: replace the batteries of the remote control of other devices.
E.g. keep away a wireless headphone from within a radius of 50".
button on the remote control.
MUTE
39