Advertisement
•
Next using your Torx5 screw driver, remove the two screws on the back housing cover.
•
Next, using your safe open pry tool, run along the long sides of the phone, this will enable you to release the back
frame housing away from the front assembly of the phone.
•
Next, using a Torx three screw driver, you were going to remove the following (9) nine screws holding your frame
in the place.
•
Next, using a safe open pry tool, you were going to release the LCD and digitizer cable flex ribbons. One is
holding by a jaw connector, you will need to release this jaw connector as shown here to release that flex cable.
•
Now, you're going to need to release the antenna flex cable holding the place on the top of the phone. Use your
finger or safe open pry tool to gently release it from the board.
•
Now, you can gently move your motherboard over to the left hand side. You will notice that the flex cable in the
middle of the board is either connected or disconnected from the board. If it is still connected, use your safe open
pry tool to disconnect it from the board.
•
Lastly, you're going to remove the camera from the actual back of the phone. Once this is removed, you can
safely remove the motherboard away from the phone.
•
Now, using your Torx three screwdriver, remove the following (4) four screws from the bottom of the phone.
•
Now, using a safe open pry tool, gently release the flex cable ribbon with the jawbone connector from the phone.
Be careful to release the jaw connector first before removing your flex cable ribbon.
Figure 2
Figure 3
Advertisement
