Adjustment Without Using Adjustment Program; Pg Adjustment - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD

5.3 Adjustment without Using Adjustment Program

This section explains the adjustment procedure without using the adjustment program.
5.3.1 PG Adjustment/PG Inspection

5.3.1.1 PG Adjustment

Described below is the platen gap (PG) adjustment.
Purpose:
Adjust the distance between the head surface and the Paper Guide Front Assy
(platen) properly and adjust the parallelism on the 0-digit side and on the 80-digit
side to ensure reliable print quality.
This adjustment is carried out when the position of the notch on the Parallelism
Adjustment Busings have changed, or when PG is not within the standard values
after PG checking.
Table 5-7. PG Positions
Application for Printing
PG Size
Position (selected from PG flag list for
(mm)
normal/head rubbing))
PG-
1.2 EPSON special paper
<APG Home>
PG typ.
Plain paper
1.7
<Mechanical
Select when PG- is too narrow
default>
Envelopes
PG+ 2.35 Select when PG typ. is too
narrow
PG++ 2.95 CD/DVD
Tools
Parallelism adjustment jigs (two types; the one for 0th column side and the
one for 80th column side)
Fixtures for precision control
Thickness gauge: 1.1 mm (x2)
1.3 mm (x2)
Phillips screwdriver
Hex wrench
Standard value
Specified PG value: 1.2 ± 0.1 mm
ADJUSTMENT
Sequence Application
Applied while capping, wiping
operations, during standby after
power-on, performing AID
adjustment.
Applied while capping
Applied while capping
Applied while capping
Applied while EJ release operation
Adjustment without Using Adjustment Program
Parallelism adjustment jig (for 80th column side)
Bit on the shaft
Figure 5-31. Parallelism adjustment jig/Fixtures for precision control
Handle the jigs with care because the bit on the shaft of dial
C A U T I O N
gauge of parallelism adjustment jigs is very fragile and gets
broken easily.
The thickness gauges to be used must be free from dust and dirt
and from deformation. Be sure to clean it before use.
Take care not to soil or scratch the Printhead.
Move the carriage right and left by pulling the belt, not by
holding down (or pressing) the carriage.
Carry out this adjustment with installing the Printhead, the Ink
C H E C K
Supply Tube Assy and the Cartridge Box Unit. (Install the CR
P O I N T
Scale after this adjustment) See
Printer Mechanism (p133) "
Artisan 810/835/837/710/725/730/PX810FW/TX810FW/
PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/
PX720WD/TX720WD/PX730WD/TX730WD have four PG pre-
settings using the APG mechanism. Use the minimum PG
setting (PG –: 1.2 mm) to carry out this adjustment.
See Figure. 5-36.
Carry out "PG Inspection
notch on the Parallelism Adjustment Busings have not changed.
Revision G
Parallelism adjustment jig (for 0th column side)
Fixtures for precision control
"4.2.5 Disassembling the
.
(p.233)" only, if the position of the
Confidential
229