For safety and correct product connection, always install the product as shown in the wiring diagram below;
4 Monitors + 2 Door cameras (2 Door locks)
22
To select slave mode for SVD-4332 (be sure connect to Slave1), perform the following procedure:
1. Remove the J1 shunt on the bottom of SVD-4332 to set to supervisor setting mode.
2. Press the SET button in supervisor mode to select [1. ID SET SLAVE1].
3. Press the + and - buttons to select the [SLAVE1].
4. Press the Interphone button to save and exit.
To set the connected unit to SLAVE device, be sure set to the SLAVE ID without overlap.
If the SLAVE ID is overlaped, the unit may malfunction.
23