Selecting The Recording Mode (Quality) - Philips DVDR 75 Owner's Manual

PROBLEM
Before you call technical support
SOLUTION
b
There is no recording on the disc: Change disc.
b
You inserted the wrong disc type: Your Recorder can play the following disc types: DVD
Video, (Super)Video-CD, DVD+R(W), Audio-CD, , MP3-CDs
b
You inserted the disc the wrong way: Insert the disc with the label facing up.
b
The disc is dirty. Clean the disc.
b
Wrong region code: The region code of the DVD and the DVD Recorder must match.
b
The child lock is on. Read chapter 'Access Control (Child Lock)'
b
You have selected or set the wrong channel number on the TV for the DVD recorder: Select
the correct channel number on the TV (channel 3 or 4).
b
The cable connecting the TV and the DVD Recorder may be loose. Check the cable.
b
It is possible that this (Super) Video CD contains a menu and the 'PBC' is switched off. You
can see this in status field '
Press SYSTEM-MENU while the (Super) Video-CD is inserted.
1
' using D or C .
Select '
2
Select line '
3
Select ' ' in line '
4
Confirm with OK and end with SYSTEM-MENU .
5
b
Your TV is not properly adjusted.
b
The disc is dirty: Clean the disc.
b
Sometimes the picture may be temporarily distorted. This is not a defect of your DVD
recorder.
b
The TV channel you want to record is not stored or you selected the wrong program
number: Check TV channels stored.
b
Disc is write-protected (cannot be recorded on): Remove write-protection or change the disc.
For more information, please see 'Preventing accidental erasing of discs' on the 'Manual
Recording'.
b
A finalized DVD+R has been inserted. Change disc.
b
You have set the wrong time or date: Check time/date.
b
You have not set the TIMER properly: Check the programmed recordings (TIMER block).
b
A locked disc was inserted: Remove disc lock.
b
A finalized DVD+R has been inserted. Change disc.
Enter the PlusCode programming number of the desired TV channel.
1
Confirm with OK .
2
Check the channel number in the '
3
If this does not correspond to the desired TV channel, select this entry field and
4
change the channel number.
Confirm with OK .
5
b
During playback via the internal TV tuner ( MONITOR button), switch to recording mode
' ' by pressing REC MODE . This will give you the best possible picture quality.
Before making the recording, select the recording mode as described in chapter 'Manual
recording', section 'Selecting the recording mode (quality)'.
b
Change the modulator channel. During standby hold on the remote the button 3 pressed to
switch to channel 3. With button 4 you switch to channel 4.
b
Have your antenna or cable TV signal checked.
'. To activate this function, proceed as follows:
' using CH- B or CH+ A and confirm with C .
' using CH- B or CH+ A .
' input field