Table of Contents
Advertisement
Connections
FM
ANT
AM
L
ANT
R
TV-IN
IMPORTANT!
The progressive scan video quality is
only possible when using Y Pb Pr
and a progressive scan TV is
required.
Option 3: Using Component
(Y Pb Pr) Video jack
1
Use the component video cables (red/
blue / green - not supplied) to connect the
DVD system's Y Pb Pr jacks to the
corresponding component video input
jacks (or labeled as Y Pb/Cb Pr/Cr or
YUV) on the TV.
2
To hear the TV channels through this
DVD system, use the audio cables (white/
red - supplied) to connect the DVD
system's TV IN jacks to the audio input
jacks on the TV.
3
Proceed to page 20 for detailed
Progressive Scan set up.
12
001-051-hts5500-55-Eng3
(continued)
VIDEO OUT
S-VIDEO
COAXIAL
Y
PB
PR
DIGITAL IN
VIDEO
AUX-IN
LINE-OUT
TO AV SUBWOOFER
12
ANT IN
2
INT IN
TO TV
3
VIDEO OUT
S-VIDEO
COAXIAL
PB
PR
DIGITAL IN
VIDEO
N
AUX-IN
LINE-OUT
TO AV SUBWOOFER
IMPORTANT!
If your TV only has a single Antenna In
jack (labelled as 75 ohm or RF In),
you will need an RF modulator in
order to view DVD playback on the
TV. See your electronics retailer or
contact Philips for details on RF
modulator availability and operations.
Using an accessory RF modulator
1
Use the supplied composite video cable
(yellow) to connect the DVD system's
CVBS jack to the video input jack on the
RF modulator.
2
Use an RF coaxial cable (not supplied) to
connect ANTENNA OUT or TO TV jack
on the RF modulator to the ANTENNA
IN jack on the TV.
3
Connect the Antenna or Cable TV
service signal to the ANTENNA IN or
RF IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV).
3139 246 14793
05/04/05, 4:16 PM
VIDEO
AUDIO IN
IN
R
L
CH3 CH4
1
Advertisement
Table of Contents
Troubleshooting
