Control and Monitoring
This chapter contains the commands to configure and monitor the system, including Telnet, file transfer
protocol (FTP), and trivial file transfer protocol (TFTP) as they apply to the following Dell Networking
S6000 platform.
NOTE: Starting in version 9.0.2.0, the enable xfp-power-updates command was deprecated for
the S6000 This command replaces the enable optic-info-update interval command to
update information on temperature and power monitoring in the simple network management
protocol (SNMP) management information base (MIB).
cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
S6000
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number [vman-
qos | vman-dual-qos] number ecfmacl number
Parameters
default
80
Use the default CAM profile settings and set the CAM as
follows:
•
L3 ACL (ipv4acl): 4
•
L2 ACL(l2acl): 6
•
IPv6 L3 ACL (ipv6acl): 0
•
L3 QoS (ipv4qos): 2
•
L2 QoS (l2qos): 1
•
OpenFlow: 0 (disabled)
•
FCoE (fcoeacl): 0 (disabled)
•
iSCSI Optimization (iscsioptacl): 0 (disabled)
4
Control and Monitoring