After Installing The Switch - Casio Catalyst 3750-E Installation Manual

Chapter 2 Switch Installation
Table- or Shelf-Mounting
To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis.
Remove two Phillips truss-head screws from the switch side panels and use those screws to attach the
brackets to the switch
hardware.
Do not use the 19-inch brackets to wall-mount the switch. The brackets are not suitable for
Caution
wall-mounting.
Figure 2-15
1
When you complete the switch installation, see the
for more information switch configuration.

After Installing the Switch

After the switch is installed, you might need to:
•
•
•
OL-9774-04
(Figure
Attaching the 19-inch Brackets for Table- or Shelf-Mounting
User-supplied screws
Configure the switch by running Express Setup to enter the initial switch configuration. For
instructions, see the switch getting started guide that shipped with the switch and also on Cisco.com.
Use the CLI setup program to enter the initial switch configuration. See
the Switch with the CLI-Based Setup Program."
Connect to the front-panel ports. See the
section on page 2-19 and the
2-15). Secure the brackets to the table or shelf with the appropriate
100 -240
V
10-5 A
AC OK
50-6 0 HZ
PS OK
2 Phillips truss-head screws
"After Installing the Switch" section on page 2-17
"Installing Devices in the 10-Gigabit Ethernet Slots"
"Connecting Devices to the Ethernet Ports" section on page
Catalyst 3750-E and Catalyst 3560-E Switch Hardware Installation Guide
Installing the Switch
1
2
Appendix C, "Configuring
2-25.
2-17