Cisco 800M series Installation Manual page 39

Integrated services router

Hide thumbs Also See for 800M series:

Table of Contents

Chapter 4

Initial Configuration

Enter the virtual terminal password, which prevents unauthenticated access to the router through ports

Step 8

other than the console port.

The virtual terminal password is used to protect

access to the router over a network interface.

Enter virtual terminal password: xxxxxx

Step 9

Respond to the following prompts as appropriate for your network.

Configure SNMP Network Management? [yes]:

Community string [public]:

A summary of the available interfaces is displayed.

Choose one of the available interfaces for connecting the router to the management network.

Step 10

Enter interface name used to connect to the

management network from the above interface summary: fastethernet4

Respond to the following prompts as appropriate for your network.

Step 11

Configuring interface FastEthernet4:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: yes

Configure IP on this interface? [yes]: yes

IP address for this interface: 172.1.2.3

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

Class B network is 172.1.0.0, 26 subnet bits; mask is /16

Cisco 800M Series Integrated Services Router Hardware Installation Guide

4-3

Table of Contents