Pioneer DDJ-SX2 Service Manual page 39

5
(5) Remove the jog dial section.
• LED PCB Assy
(1) Remove the Windows lens.
Insert a slim rod in the hole for disassembly
in the jog dial section bottom side, and remove it.
• Bottom view
(2) Remove the LED & COVER Assy.
(3) Remove the JW cover by unhooking the
6 hooks.
(4) Remove the LED PCB Assy.
• When replacing the LED & COVER Assy or
WHEEL Assy
When replacement of the LED & COVER Assy is required, the
Windows Lens must be detached, because the Windows Lens is
attached to the WHEEL Assy with double-back tape, which is
attached around the outer periphery of the Windows Lens as a
tube, and the LED & COVER Assy is placed in between them.
Once the Windows Lens is detached, the double-back tape cannot
be reused. The Windows Lens may not be reused either, because
it may be scratched, depending on the manner in which it was
detached.
When replacement of the WHEEL Assy is required, the Windows
Lens must also be detached and may not be reused. Note that
when replacement of the following Assys are required, replace
them together with the parts mentioned below.
Double-back tape is supplied with the WHEEL Assy.
· When the LED & COVER Assy is to be replaced:
Double-back tape (TWIN ADHESIVE) (must),
Windows Lens (if necessary)
· When the WHEEL Assy is to be replaced:
Windows Lens (if necessary)
5
6
Jog dial section
Windows lens
LED & COVER Assy
Hole
WHEEL Assy
DDJ-SX2
6
7
5
1
2
JW cover
3
LED PCB Assy
4
3
3
3
3
3
7
8
3
• Bottom view
39
8
A
B
C
D
E
F