Honeywell FocusPRO TH6110D Installation Manual page 6

Installation Guide
Follow the procedure below to configure the thermostat to match the installed
heating/cooling system, and customize feature operation as desired.
Function Setting
number
To begin, press and hold the A and FAN
buttons until the display changes.
Press A or Y to change settings.
Press NEXT to advance to the next function.
Press DONE to exit and save settings.
Shaded areas below apply _ to TH6220D.
1 System type 0 1 heat/1 coo| conventional
1 1 heat/1 cool heat pump (no aux. heat)
2 Heat only -- 2-wire systems, 3-wire zone valves (Series 20), and
normally open zone valves
3 Heat only with fan
4 Cool only
5 2 heat/1 oool heat pump (with aUX. heat)
6 2 heat/2 COOl conventional
7 2 heat/1 cool conventional
8 1 heat/2 cool conventional
2 Changeover valve
(O/B terminal)
0 Changeover valve (O/B terminal energized in cooling)
1 Changeover valve (O/B terminal energized in heating)
3 Fan control
(heating)
0 Gas or oil furnace equipment controls fan in heating
1 Electric furnace thermostat controls fan in heating
5 Stage I heat cycle 5 For gas or oil furnaces of lees than 90% efficiency
rate (CPH: cycles/hour)* 1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnases
8 Stage 2 heat CYCle 5 For gas or oil furnaces of lass than 90% efficiency
rate!Auxiliary heat 1 For steam or gravity systems
o
cYcle rate (CPH) 3 For hot water systems & furnaces of over 90 Yo efficiency
9 For electric furnaces
8 Emergency heat cyele 9 For electric emergency heat
rate (CPH)* 1 For steam or gravity systems
o
3 For hot water system8 & furnaces of ever 90 Yo efficiency
o
5 For gas Or sit furnaces of less than 90 _/oefficiency
*[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH] Continued on next page