Installation And Usage; Unpacking; Installation Site And Direction Of Printer; Power Adapter Connection - Pioneer STEP-5e User Manual

STEP-5e User Manual

4 Installation and Usage

4.1 Unpacking

Upon receipt of the package, check if any items are missing or damaged according to the packing
list, if so, contact the local dealer or manufacturer.

4.2 Installation Site and Direction of Printer

1) It's recommend printer is installed at a level table surface. Wallmount not recommended.
2) The printer should install at a flat and steady place. It's recommend that install the printer at
horizontal line. The angle of inclination should not exceed ± 10°(paper feed direction) if tilt
install printer, it does not allow to tilt by other direction.
3) Keep printer away from source of water
4) Avoid the printer on place where it is vibration and shock
5) Ensure printer ground connect is safe
6) When the printer is at operation and maintenance, it is recommended to retain the enough
space to ensure the printer can work in reliability and ease of operation.

4.3 Power Adapter Connection

1) Make sure the printer's power switch is turned off;
2) Put the cable plug of power adapter facing up at flat side, insert the rear of the printer power
connector;
3) Turn the power adapter input power;
4) Pay attention about disconnecting or connect the AC adapter at right method, or likely to
cause damage.
The plug of power adapter is designed in a switch type, when accessing power adapter and uttered
the voice "click", it means the connected socket switch is locked the adapter connect well, otherwise
please connect again.
When pulling out the adapter, please pinch the shell of power adapter and pull the switch up, when
the switch is fully opened then pull out the power adapter.
Don't put forth your strength to pull the plug by squeeze at any of place of power adapter. Because, it
is more difficult to pull it out and may damage the cable.
Page 10